OK, so it took a week. Using a modern digital conditioning charger is not the quickest way. 0.86 amps was as high as it went, and most tutorials suggest 10 amps. But it did work.
The harvest, and a clean(er) looking tank. I'll use a single tap set up when it goes back together.
Then onto the rewire. It really is a mess. I've decided to start from scratch.
 |
| I've just ripped this lot out. I sat with the wiring diagram and really couldn't figure out how this actually worked. |
 |
| Wire gauge all over the place, colours not matching. |
 |
But at least its safe
|
Everything apart from the two switches inside the headlamp is pretty much done. Alternator, Rectifier, Battery, Horn and Dipswitch all wired up (not tested yet mind) but after looking at the above switch I lost the will to continue 😜
No comments:
Post a Comment